Difference: FirstElectricalModule (2 vs. 3)

Revision 32017-07-17 - TomErikHaugen

Line: 1 to 1
 
META TOPICPARENT name="ElectricalPrototypeHybridSeven"

First Electrical Module (ABC130)

Line: 26 to 26
  After flipping the wire bonds we were able to run all of the tests and get results.
Added:
>
>
Results:

HV Biasing

The original plan was to follow the wire bond diagram for module construction. After talking with Craig it became clear that we should vary the plan some. To correctly connect the HV we had to do the following steps:

  • Solder a wire on the connector pins to short HVret and LV GND '
  • Connect the four corners with AC connections, then connect one of the inner corners of the hybrid to the bias ring to route the leakage current into the HCC
  • Not connect the HVret on the hybrid to the frame, as R2 creates a lot of noise for the system.
 -- Tom-Erik Haugen - 2017-06-05

Comments

 
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2020 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback