Difference: ItsDaqSoftware (1 vs. 3)

Line: 1 to 1

META TOPICPARENT	name="DaqDocumentation"

Changed:

<
<

ItsDaq Software

>
>

This is the software for the interfacing with the DAQload (the root script Stavelet.cpp).

Line: 1 to 1

META TOPICPARENT	name="DaqDocumentation"

This is the software for the interfacing with the DAQload (the root script Stavelet.cpp).

Added:

>
>

This is an update of the SCTDAQ software from the SCT. It is largely documented on the ATLAS TWIKI. I have included some of the useful pages below.

Useful information about ATLYS, including the firmware that is loaded to the board: ATLYS ITSDAQ

Description of configuration file (st_system_config.dat): ITSDAQ Config Files

Description of GUI interface and different tests: DAQ GUI

General page with these links and more: Strips Upgrade DAQ

If you cannot communicate with the DAQload:
- Check that the configuration files correspond to what you are testing

Line: 16 to 26

Deleted:

<
<

<--/commentPlugin-->

\ No newline at end of file

Added:

>
>

<--/commentPlugin-->

\ No newline at end of file

Line: 1 to 1

Added:

>
>

META TOPICPARENT	name="DaqDocumentation"

This is the software for the interfacing with the DAQload (the root script Stavelet.cpp).

If you cannot communicate with the DAQload:
- Check that the configuration files correspond to what you are testing
If you can get the HCC address but not the chips ID
- Change the phase of the signals (through root type e->ConfigureVariable(50,2))
The script Stavelet.cpp which opens the GUI crashes very often (usually after running about 2 tests)
- To gain control again when the GUI stops updating enter e->CacheMasks(1) this clears the cache and allows for communication again

<--/commentPlugin-->