Shipment of TM Modules

The thermomechanical modules were shipped to BNL in 2 separate shipments of 5 modules each.

Shipment Boxes

The modules sit inside of a testframe which allows for connection to the DAQ system these are documented on The ATLAS TWiki. There is also a shipping box that is designed to fit around these frames. LBNL produced 15 of these boxes for the US including the plexiglass covers and the 3D-printed spacers.

<-- Image of shipping box --!>

Test Frame

There are 2 versions of the test frames, there are slim cut and wide cut, these accomodate the 2 different sizes of sensors

Test Frame Spacer

The spacer protects the cover from pressing down on the wire bonds and the powerboard coil. It has spaces to accomadate for the DAQ connections, along with connections for nitrogen along the sides of the box. The 3D model for version %f is included here. This was uploaded to and printed in the "strong flexible" plastic.

The product recieved required a lot of cleaning (multiple hours). There was a lot of dust encrusted over the whole surface and throughout the honeycomb. This was cleaned manually with pushing the dust out, and blowing it off with compressed air.

Suction Pads

Plexiglass Covers

Nuts and Bolts



-- Tom-Erik Haugen - 2017-06-27


This topic: Strips > WebHome > GlueDocumentation > ThermoMechanical > ShippingTmModules
Topic revision: r3 - 2017-06-28 - TomErikHaugen
This site is powered by the TWiki collaboration platform Powered by PerlCopyright © 2008-2020 by the contributing authors. All material on this collaboration platform is the property of the contributing authors.
Ideas, requests, problems regarding TWiki? Send feedback